The Headphone amp is a bit weak by default.
Dan showed me a command prompt to adjust on a one off basis
but there really should be in the JAm link GUI a Headphone/Output
gain setting 1-10.
Even when you use Jamlink in the more advanced (prefered setup)
this will be usefuile for critical balancing of signals.
There's an internal "default" setting we can tweak for our next firmware release. I think we should kick up the default output by a couple clicks.
--DAN--
The low headphone level will be fixed in the next firmare update.
Be on the lookout of this in the next couple of months.
Any word on the upcoming release of this feature? I'm dealing with a very low signal to noise ratio, so there's a lot of white noise being amplified along with the audio signal when I use a headphone amp.